Just got my laser. I have it working (almost). I can do a really nice raster image but I can't currently do a vector CUT. The machine and software is not the issue I don't believe. I believe the issue is that there must be some term / adjustment / setting / that I'm overlooking. So here is my question, if I have a thin piece of ply (1/8th inch) what would be a good set of starting points to try and use for doing a vector cut? I.E. speed, power, etc,. Or am I all wet and it is very machine / software specific? I have a 40w co2 laser. Thanks in advance for any assistance. Russ