Results 1 to 15 of 17

Thread: How to clamp?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-03-2005, 1:13 PM #1
    Byron Trantham's Avatar
    Byron Trantham
    Byron Trantham is offline [OP] Member
    Send a message via AIM to Byron Trantham
    Join Date
    May 2003
    Location
    Fredericksburg, VA
    Posts
    1,900

    Question How to clamp?

    I need to attach two boards using biscuits. The problem is the "normal clamping surface" is too long for clamps - about 70". I have band clamps that are large enough but I don't think I will get enough pressure to bring the joint home. I have attached a couple pics to show the problem (I hope).

    Any suggestions will be greatly appreciated. One note, I could attach to the two center dividers and use them as a clamping point - Yes? Or would this put too much pressure on the joint? These joints are also biscuits.
    Attached Images Attached Images
    If sawdust were gold, I'd be rich!

    Byron Trantham
    Fredericksburg, VA
    WUD WKR1
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Clamp Racks
    By Bruce Page in forum General Woodworking and Power Tools
    Replies: 54
    Last Post: 03-28-2016, 10:58 PM
  2. Convert a Kreg right angle clamp to a face clamp
    By Bryan Nuss in forum General Woodworking and Power Tools
    Replies: 7
    Last Post: 04-11-2005, 7:07 PM
  3. Clamp Meter suggestions
    By Steven Wilson in forum General Woodworking and Power Tools
    Replies: 6
    Last Post: 04-11-2004, 8:24 PM
  4. Jorgenson Clamp Marketing Strategy
    By Dave Avery in forum General Woodworking and Power Tools
    Replies: 27
    Last Post: 08-26-2003, 11:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules