I have been trying to laser a moose antler. One of the problems that I am having is getting the settings right. If I want to engrave something deep down and need the table to be down what settings do I use?
I have tried:
Wood (whatever type)
Material Thickness: 1”
Fixture Type: Custom
Height: 7
But it occurs to me that if I were trying to engrave the top of an 8" box I would use the same settings. This doesn't make sence!

Can anyone understand my dilema and offer some suggestions or solutions?

So far, I haven't been able to make a mark on it. So I tried a wood plaque at the same depth and it did not laser properly either.