hi all. been a lurker for a while but now have a question maybe some one can answer. I have 2 Epilog machines, and i notice that they both pause when cutting some straight vector segments. there is no node at that point in the geometry of the shape and the epilog tech offered a less than satisfying reason. This particular cut is a straight line and it is exactly on the x axis. The tech at epilog said that the shape "must" be slightly angled and the encoders cannot respond in such minute increments so it pauses for a pulse then resumes. Picture your laser cutting out a square in 3mm baltic birch. In the middle of one side it pauses for a beat, then continues. This happens even when there are no nodes in that span. I also don't remember this always happening but can't say for sure that it is related to a firmware update. Has anyone else experienced this. Thanks.
Gene