Just got done with my power feed for my G0759 mill. Basic inspiration comes from the Grizzly power feed. The box is 2 pieces of aluminum angle, drilled tapped and screwed together. The motor is a power seat motor and the shaft was milled to accept a 3/8th 14mm socket. The 14mm socket was friction fitted into some round aluminum bar, then the bar "grooved" and tapered to except an aluminum plate made into a fork. I peened the fork into a piece of steel bar scrap and tapped it for a 1/4" bolt for the handle shaft, then epoxied a ball on. The electronics are from Amazon as is the Switch. Overall......so far it works well. I did one similar on a HF mill, but had to engage the socket with my fingers. The motor speed controller will take the motor from a crawl to pretty fast.



Shifter Engaged.jpgShifter Out.jpgFinished.jpg