Results 1 to 13 of 13

Thread: Felt the need to contribute.

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 03-24-2017, 1:42 PM #1
    Jeff Body
    Jeff Body is offline [OP] Member
    Join Date
    May 2015
    Location
    FL
    Posts
    295

    Felt the need to contribute.

    1st - I want to see if it's showing I'm a contributor now. After all the help I've gotten from this forum I felt it was time I helped contribute to the cost little.

    2nd - I want to thank everyone here for all their help. This has been a fun adventure over the last few years. I couldn't have figured out some of my problems without you guys.
    I'm looking forward to learning more.

    Thanks
    Last edited by Jeff Body; 03-25-2017 at 1:24 AM.
    Jeff Body
    Go-C Graphics

    China 50W Laser
    Model # SH-350
    Controller RDC6442
    Vinyl Plotter Graphtec CE600-60
    Software used
    Inkscape, FlexiStarter, VinylMaster 4, RDWorksV8
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules