Results 1 to 7 of 7

Thread: problem with table top glue up

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-23-2018, 12:31 AM #1
    tom blankenship
    tom blankenship is offline [OP] Contributor
    Join Date
    May 2005
    Posts
    38

    problem with table top glue up

    I have a question about a table top glue-up.

    I glued (using Titebond II) and clamped two boards together for a small table top. As I tightened the clamps I noticed that a half inch long portion in the center of the joint showed no glue squeeze out. Fearing that the joint was starved for glue I quickly separated the boards (within 30 seconds) and applied more glue to the entire length of the joint and clamped the boards together again.

    I later scraped the glue squeeze out away and the joint looked very good. So, is this re-glued joint as strong as a normal glue joint? Should I be concerned about the long-term integrity of the joint?

    Thanks in advance.

    Tom
    Last edited by tom blankenship; 05-23-2018 at 10:59 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules