So the sharpening jig came yesterday. I spent about and hour and a half messing with it and trying to sharpen my 4 chisels. It did not work on the 1/4 inch. It just wouldn't grab it properly. From half inch up, it grabbed them, but no writing anywhere to tell me what protrusion for what angle. So I set it to the angle that came on the chisels. I pulled out my fresh package of wet/dry sand paper and went to town on them starting from 220 grit to 400 to 600 grit. Now I can see very small scratches in the face and on the back of the chisels. I try to shave with it and nothing. I try to cut a piece of paper and the paper folds and rips but doesnt get sliced. Do I need to go to a finer grit of paper or do I need to adjust my angle or am I just screwing up somehow?