Hoping to reduce my labor time installing the top and bottom mitered trim on my Caskets.

It's just Pine strips 2-3" wide ripped from 3/4" S4S stock.

I use 1 1/4" brad nailer and Titebond thick no run glue.

Specifically I am wanting to speed up my cutting to length and fitting.

I feel somewhat awkward at times like tripping over myself is best way to put it...

I mean not that bad, but I KNOW it could be done more efficiently.

Suggestions ?

Thank you, Marc

Caskets Two Brenda 4-17-18 Black camera 038.jpgCaskets Two Brenda 4-17-18 Black camera 019.jpg