As i get up and running with this Shark HD4, i wanted to get a few more bits to play around with. The spindle is either 1.5-2.2kw with a 1/4" collet. I currently have two 1/4" end mills and a 90° v bit. I was going to pick up some form of a surfacing bit, a 60° v bit, and the rest im up in the air on. I assume a 1/8" end mill is worthwhile to have. Do people typically need more detail than that? 1/8" sounds like im going to break bits, let alone going 1/16" or similar.

Anyone have recommendations or a favorite source? In the past ive used router bit world for freud bits.