Kreg cabinet door hinge jig thoughts?

[Bruce Wrenn]

If you already have a set of Forstner bits, I think the 1-3/8" is the same as 35mm. I know one of them is, but should be pretty easy to check.

The trouble I found trying to use a 1 3/8" Forstener bit on 5/8" and 3/4" slab doors is center point can leave a dimple on face side doors Using proper inset from tables (Blum,) bore 35MM hole. Then using hinge and a square to get hinge square, then use vix bit to bore screw holes