-
I left it alone. The teeth were evenly done so I followed Mike Allen's advice and proceeded to sharpen it. Jointed it.checked teeth. Bought a new caliper for measuring set, jointed again, sharpened teeth (I also got the veritas guide), quick joint, then touch up sharpen, then a stone down the side to get rid of burr.
Climbed on top of bench and rip cut length of 3/4 board amazingly fast.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules