So when I sit down in the Gazebo to enjoy the afternoon, and maybe sip a cold one.....I'd have a place to set it down between sips.......and maybe a place to set a plate-full of food from the grill...
Gazebo Table Project Post, drawer shut.JPG
Bag of Charcoal at the ready, even....
Gazebo Table Project Post, drawer view.JPG
Lumber that shows is Ash....inside stuff is Pine..bead details are on the bottom edges of the aprons, and running down the outside corner of the legs...
Gazebo Table Project Post, drawer open.JPG
Drawer works just fine. Drawer front uses half blind dovetails....drawer back uses a dado...
Gazebo Table PIP, drawer opens.JPG
Stain is called "Gunstock", by Minwax....and there be 2 coats of Clear Gloss Poly over that...

Legs are tapered along two faces. Legs are joined to the aprons via mortise & tenon joints..
Gazebo Table Project Post, drawer view.JPG
back end was a bit on the grainy side
Gazebo Table Project Post, end view.JPG
Top has wide bread board ends....
Gazebo Table Project Post, shiny top.JPG
had to make the legs as a glue up....didn't have any 8/4 Ash on hand...

Thanks for looking in!