My latest rabbit hole. I picked up the Parf Guide Mark II from Lee Valley recently and a sheet of 3/4” MDF and now that I am finishing the floor re-finishing project at the house am ready to proceed to making a table or two. I have watched Peter Parfman’s YT’s and checked out Festool’s site and noted dimensions but want to ask those working on MFT’s what they like for size and why. I will leave my Hitachi SCMS on the Dewalt horse outside on the porch. I don’t like it indoors for room & dust collection reasons. I have the Festool 55 and assorted rails as well as the Parf dogs, etc for this. This is proving to be another costly venture, but what rabbit hole isn’t, as I think I may not be able to do without the Festool 1400 router to run on the rails. Much obliged for any suggestions.