Need more help adapting to use my Roman/low workbench. Y’all helped me a lot with the technique for long faces. Now I need to figure out what to do with long edges. It has a face vise and a hole for a holdfast on the other leg. Putting on those make the board fairly low if I try to stand. Tried sitting on the bench from the other side but that feels awkward. Sitting in my chair, the board is a little tall and it’s hard to go along the length.

suggestions for edge planing on a low bench? Or for disabled folks in general?

here’s my best but poor attempt to get it done…
6E235F31-E82D-428F-9D95-F04DA63E91EB.jpg5E890498-383D-4349-9B93-234A17C29929.jpg93F98625-8800-49CD-8A1F-723FDC5A2A89.jpg