Hi All

I'm gearing up for a project and haven't touched my tools in a long while. Long of the short I decided to check blade/miter/fence alignment, as well as my unifence cursor accuracy.

Some questions for all, before I make any more adjustments.

1) how accurate should my cursor be? I messed with it a bit and got it to .006ish of my measurements. Example I set cursor at 1" and test piece was .995-.996" in width. The adjustment on the unifence is just done by loosening two screws and manually moving the cursor. Not sure I can accurately adjust .006" of a inch by hand. Is this accurate enough / do you think I can do better?

I obviously would like to see 1.0" on the dot. Just not sure that's achievable.

Thanks
Michael