Of the Tool Cabinet....because..
Tool Cabinet Rebuild, start here.JPG
This was a mess....hangers weren't doing the job....some were just a couple screws

Found these at Wall E World....about $3 or so each..
Tool Cabinet Rebuild, new hangers.JPG
Thought I could use the bench vise to squeeze some of them a bit tighter....and also toss the 2 screws that came with each hanger....too hard to start, and way too long..

Main goal was to gather 80% of the Eggbeater drills into one location...instead of all over the shop....I have 2 BIG eggbeaters that won't fit in the door...like that GP No. 5A in the first picture....those 2 will go over with the Brace drills, later..

Tool Cabinet Rebuild, out of hangers.JPG
Took a while,,,bend a hanger to fit a drill, mark the spot to hang it up...drive 2 screws..move over a bit, repeat..The 2 Pilot Hole Drills were doubled up onto one hanger by themselves. Still had a couple hangers left....good place to put the hammers? Left the 3oz ball pean on 2 screws..

Finished up door ( for now)..
Tool Cabinet Rebuild, almost done.JPG
Not too sure WHAT will go into the big empty area..yet.....need to go back and buy enough of these hangers to hang the Brace drills up, and the 2 HUGE Eggbeaters..

Stay tuned...

This and spending an hour to replace the lockset on the Bathroom door...