Howdy. I've had the Incra TS-LS fence on my table saw for about 14 years. Lately, the micro adjuster has gotten difficult to rotate. After 14 years I figure it needs a good clean out and lube job. However, it's not obvious to me how to do that. There is no info about lubricating (or any maintenace) of the fence/positioner in the manual or on Incra's website. I only found one post in another forum that essentially said to dribble a lubricant onto the wheel and work it in. I'm hoping someone here on the Creek has done this and can provide me with some direction on how to go about this.

Thanks!