I think I'm going to go ahead and take the time to put up a wall between where my new lathe will be and the rest of my storage room...but now I need to decide on dust collection. At first I was just going to wander to my local woodworking store and see what I can afford but I just finished reading some of Bill Pentz's (sp?) site so I am a little bewildered. It seems the best route is to run a cyclone collection system and vent the air out of the area completely (do I have this right?) I have a small daylight window just above where the lathe will be so I am pretty confident I can vent air out of that (probably swap the window out for some plexiglass and add a port for some tubing.) Bill has a link to the Clear Vue cyclones on his site and I see they have a small unit which attaches to a vac. Does anybody have any experience with these?