Good morning, I have a table top im working on. Its 80 inches long, where two boards meet its raised about 3/32" of an inch for about 16 inches. Its 1.5 inch white oak. Whats the best way of getting this flat.Its all glued up.
I was thinking of buying a pad sander.One of those rectangualr types.

I have a 3"x21" porter cable belt sander im afraid I might groove with that, or maybe i should just use the weight of it an go very lite.
I also have a vibrating sander shaped like a iron.

Any suggestions I'd appreciate.

Thanks

Ill post pics in a few days when its done.