I recently did this cutting board with VectorClip3D artwork of the rabbit model. I used a commercial cutting board and machined this into the back side of the board (15" x 12"). Cut3D by Vectric was used to generate the toolpaths.
After machining, I moved it to my Laser Engraver and engraved the design into the wood around the rabbit carving. I used a .0625 Dia. Tapered bit with a step-over of .0063...took about 3 hrs to carve in the 'Bot', but I had 'no' finishing work after it was done.
As final touch, I coated it with Canola Oil to bring the luster in the wood back up. The carving was .436" deep and shows good depth and detail.
The flip side of the board is your conventional cutting board. When not in use it can be flipped over and displayed in the kitchen.
Reply With Quote