Good evening everyone. I just measured the Delta hybrid I got and I have right around 7 thousandths of runout on a forrest WWII with a stabilizer. I thought that was a bit high, so I measured the runout on the hub behind the arbor, and I'm seeing between 0.0015" and 0.002". Somewhere I read that Delta's spec is 0.002", so I don't have any recourse.

Given that, is 0.007" at the teeth (or just before them in terms of the radius) enough to cause any problems with quality of the cut?

Is there anything else I should be doing?

I'm going to have to adjust the trunnion because the back is closer to the miter slot by 0.02", so I'll remeasure the runout after that to see if it has changed.

Any advice?

Thanks in advance.