I got my new TimberWolf blades in today and while I was putting one on I thought I would just check things over again to make sure everything was set correctly when I first set it up.
Well I found pulleys were not in line like they should be, I had worked on it for an hour when I set the saw up but I guess I had let is slip.

So I tried to get the things lined back up but what a PITA.

After screwing with it for about 20 min. that was it, there had to be a better way.
So here it is, it is not fancy looking but it works and makes the job 10,000 times easier and faster to do.
Just some scrap 3/4 plywood, some scrap red oak and a few wood nuts and about 30 min. work.
Now after the pulleys were lined up I could then adjust the belt tension with no problem.

P3154210.jpg P3154211.jpg

P3154214.jpg P3154216.jpg