EPILOG SUMMIT Raster problem
Hello All !

I am new to this board and hope that someone with some previous experience with the Epilog Summit laser may be able to point me in the right direction. Our old Summit laser will vector cut no problem but will not raster. We have moved the machine to a new location, but as the machine will still vector cut ok I doubt that the machine has a mechanical failure. We are using a new PC which is probably where the problem arises. When rastering, the gantry moves to the correct position and the head moves as if engraving, however the laser is not firing. The machine will vector cut no problem. The machine is using the old 3.3A firmware, so I have installed the correct drivers from the epilog site on a Windows 98 PC. I can report:
  • Have ticked raster & combined boxes, no effect.
  • Machine will vector cut AOK
  • Have tried color mapping, both with and without, no change
  • Have tried computer control of speeds / feeds on and off - no change
  • Have tried converting image to bitmap - no change
  • Have tried converting to curves - no change
  • We are using coreldraw 8
I suspect I have something set incorrectly in the driver or possibly the port settings, but not sure. Have consulted the technical information available but can't find any helpful hints.
Can anyone point me in the right direction?

Thanks - Sean