Recently I acquired two Delta/Rockwell 14" band saws (BS), model 890, manufactured in 1947 and in 1950. The saws are in good condition needing mostly new tires. I got one to give to my grandson, and I want to paint it before giving it to him. I am working on this BS.
To do a good paint job, I am disassembling the BS and cleaning off the years of grit, grime and grease. While I was in the process of taking the axle assembly out of the lower housing, I ecountered difficulties removing the assembly and cannot go any further. The driven pulley has been removed but not the14" wheel. It is threaded onto the axle very tightly.
So, before doing any more damage than I may have done already, I need epert advice about removing the axle assembly from the lower housing.
Thank you.
Edinmin