My new Akeda BC24 dovetail jig was just delivered today. Unfortunately, the C-kit that contains all the bits, dust collector and various pin/tail fingers is being shipped separately from Akeda in Canada. So I can't cut any dovetails just yet.
I have been reading all the reviews on the jig and am very excited to start making some drawers for my next project. I just sold my 24" PC Omnijig, after messing with it just to get it dialed in for one or two drawer boxes. Too much of a headache setting it up.
The Akeda BC24 came in one compact box; opened it up, no assembly required! It's ready to go as soon as I get the DT bits. The longest part of the assembly was making the plywood base to secure it to my workbench.
This is an impressive jig; the design is simple and innovative. It's well built of quality materials and the fit and finish is very good. Can't wait to get going with it.
The only thing I wish is that the base system came with a set of DT/Straight bits, at least for 3/4" material. Would like to have done some test DTs tonight. Hopefully the accessory kit will come soon.
Here's a couple of pics of the jig, just waiting to rout! When I get a few cuts under my belt, I'll post my impression of the jig.
IMG_2912.jpg IMG_2913.jpg
IMG_2914.jpg