I was looking at my bench top drill press today thinking that it's one machine I have not tricked out very well yet. It's just a bench top model, and about all I've done is make a melamine table and a simple pipe clamp fence--barely a step up from the old C-clamp and board method.
I don't really use it very often, but when I do I often end up fiddling with clamps and little blocks of wood to create a stop system on the fence.
Any suggestions on how to build a better fence with maybe a couple flip stops on each side? I have the Kreg stop system on my miter saw (you guys do have a stop system for your miter saw right????), but purchasing 4 flip stops and track seems expensive for the drill press.
Thanks, Steve