This past weekend I built a couple of shop cabinets for hand planes and saws. Next weekend I will put doors on them with hasps so I can lock them up. Nothing fancy here just scrap pine common lumber and cdx plywood for the back. The pine had a lot of dents, scratches etc., but I used it anyway because it was going to be painted. Had some tearout when I routed the dados for the shelves. Oh well. There are two more shelves to glue up and install. I find that when I'm using cheap materials I don't pay close attention to detail as I would if I were using good wood. Just git er done. Anyway my saws and hand planes have a new home and I now need to build a chisel cabinet and a place for spokeshaves and drawknives. The only problem I have now is that I am running out of wall space. I built these to sit above a carpenters chest I bought and it is rapidly filling up. One step closer to getting organized.