I am playing at making a few hollowing tools. I have some HSS Steel bits that I would like to cut in half. Any way to do it without special tools? These are the square type.
I am playing at making a few hollowing tools. I have some HSS Steel bits that I would like to cut in half. Any way to do it without special tools? These are the square type.
Just score all four sides, put 'em in a vise, and snap them off.
You can score each of the four sides with the corner of your grinding wheel. Doesn't have to be deep, just enough to see the score. Then hold the bottom half in a vise and snap the other half off with a pair of pliers. It works like a charm. Do wear eye protection, though.
Thank you, I will give it a try.
if you have a 4" grinder, go buy some super thin cutting wheels, they are around 1/16 thick. They will cut it just fine.
http://www.tooled-up.com/Product.asp?PID=130615
neil
_____________________________________
The wooden Potter
I have found that scoring one side of the stock, clamping it close in the vise, and a quick whack with a hammer will snap it easily.
Ditto the scoring and snapping method. Make sure and dress your grinding wheel before attempting so that you have a nice crisp edge. This way you waste less of the bit. 1/16" deep grooves in 2 sides (or 4 if you want) is about all you need if you have a vise; just do like John Keeton suggested. Most important is to really have a very firm grip, and keep your fingers clear of the wheel!
I support Neil, I have never been a user of the edge or corner of a grinding wheel for any purpose but do use a four inch grinder and the thin cutting disks for all tool steel cutting. The lottery of striking a dangerous blow to make a deliberate break can have disastrous consequences.
Also the cut off black wheels on a Dremel will also provide an exceptional cut in Tool Steel.
Have success works safely for me.
Regards Peter.
Peter, good comments. Perhaps I should clarify. I don't use my sharpening grinder to score the HSS. I use an angle grinder with a 4" wheel in it that is used for sharpening my bush hog blades, etc. It just takes a touch. And, when I snap the HSS in a vise, a very light tap with the hammer is all that is required. Not much in the way of danger factor, but obviously eye protection is in order.
"...clamping it close in the vise, and a quick whack with a hammer..."
Just be sure that when you do that, that the piece that goes flying when you whack it does not land in a pile of sawdust! Of course, if you keep your shop like "some people", there will be no piles of sawdust. Even so, the piece could skitter under something but, one way or another, according to "Murphy's Law", you will never find it again until one day in the distant future when you are moving or something...
David DeCristoforo