Originally Posted by
Michael Simpson Virgina
No this was a CDR I downloaded from this site. I just exported it as an eps then imported into Cut2D. Cut2D lets you take any 2d drawing and add tool paths to any of the shapes. It then outputs Gcode directly to Mach3.
Cut2D is only $149 and I feel its one of the best values out there for the CNCer who does not want to spend a bundle on software.
Heh, I was the uploader, I was quite surprised to see it in use Looks great!
-Garrett Nors
45w Epilog Helix ♦ Dahlgren Wizzard 2000ST (currently down for the count) ♦ CorelDRAW X3 ♦ Adobe Illustrator & Photoshop CS4