I have a Forrest WWII 10" 40T blade that makes good cuts. In trying to set up my saw for better accuracy I have found that over the diameter of the blade there is a large variation in the runout. It ranges from -.003 to +.012, and it seems like it is worse with the blade dampener. The original Craftsman blade with or without the dampner has better numbers. I will get the WWII sharpened and tested but I am looking for a thin kerf blade and am a little hesitant about buying another Forrest.
I checked for arbor runout and it was: .0015 at the most.
Any suggestions on a good blade?