Without going into too much detail, I just completed my first "true" woodworking project this weekend: A closet organizer for my daughter. All in all I'm very pleased with the results but I ran into a problem with the drawers.
I built two drawers out of 1/2" (15/32") plywood using pocket holes. Again I am very pleased with the drawers themselves but I made the clearance for the drawer openings too tight. My question is should I use a plane (hand or power) or belt sander across the tops of the the drawer panels to trim it down? Any other suggestions?
Any suggestions/advice is as always greatly appreciated!! Thank you.
John