Hi all, I have been planning on building a MAME cabinet, and as such, I will have to have some very big pieces of MDF cut. So this is my question: If I had the option to have HD/Lowe's cut it, or haul the whole 4' x 8' sheets over to another shop, and cut it myself/with the help of a friend, what would you recommend? I would just have HD do it, except I'm not sure about the accuracy/repeatability. Here is a link to the page with the cut plan, and the one that says Rev. 7 is the one I'm talking about. So I guess one of my questions is: have you had good experience with HD/Lowe's and their panel saws? There are a couple problems with doing it myself. To start with, my friend with the panel saw was pointing out a problem to me where the action was not smooth the whole way down. Also, if I messed it up, I would only have myself to blame. On the other hand though, I would have more control over what was going on, and could take more time to make sure it came out right. But either way, another questions I have is: How would you do these cuts? What I mean by this is, in what order would you make these cuts? I think I will have to do a lot of them with a jigsaw, especially the angled cuts, as I can't think of any other tool that would be able to do that. And if anybody needs help visualizing it, I made a Sketchup model Here. I figured that would be a good first step when first planning it out, as the cut pattern is not extremely helpful in trying to figure out how it goes together. I will be posting progress on my blog at http://projectthings.blogspot.com if anybody is interested.