Essentially the same size. Detailed comparison in Derek's review http://www.inthewoodshop.com/ToolRev...w%20Plane.html
Essentially the same size. Detailed comparison in Derek's review http://www.inthewoodshop.com/ToolRev...w%20Plane.html
You sir, are a bad bad man.
I do hope theres a tool roll though. 37 irons? Dang.
And I hope the large plow is unhanded, so I'm not tempted by two of them.
Somehow I think Rob will try to break the record for the number of irons with the large plow.
Hmm, that would be a good April Fool's tool. "Buy our new extra large plow plane. You'll need both hands to lift it, but it comes with 237 irons all in one convenient Veritainer. You can cut open a tin can with iron 58 (normally used for hogging off material) and then plane wafer thin slices from a ripe tomato with iron 113 (our 36 degree radiused smoothing iron)."
Last edited by Gary Herrmann; 04-20-2012 at 2:13 PM.
Where did I put that tape measure...
Rob,
As your current plough plane is very similar to the Record 044C, will it be possible to use your new T&G option on it as well?
Maurice
I have not been here for some time on any kind of a regular basis and what do I find more baubles from Rob Lee the man is truly devious.
Just a matter of curiosity but at some point will there also be groups of hollows and raounds to go with either the small or large Plow planes.
I would add I do have the small one now and I almost giggle everytime I use it it is that much fun.
Craftsmanship is the skill employed in making a thing properly, and a good craftsman is one who has complete mastery over his tools and material, and who uses them with skill and honesty.
N. W. Kay
Hi Rob,
Sounds very cool. One question. Do you plan to make a bigger plow plane one day ? Or maybe add some nickers on the plane for cross grain planing ?
Probably new holes in our wallets on the way
Thank you.
Last edited by Erwin Graween; 04-23-2012 at 10:04 AM.
Blast!
I just purchased a Montgomery Ward 45, because I couldn't wait any longer for the upgrade to the Veritas Small Plow Plane! Looks like I'll be saving up again
Craig J. Brain
Canberra
One thing I think would be cool to see would be side beads. Maybe with interchangeable beech soles? In say 1/8", 3/16" 1/4" and 1/2". Like this Kimberly...
Last edited by Trevor Walsh; 04-25-2012 at 7:35 AM.
Trevor Walsh
TWDesignShop
:O
That would be great if you could make hollow and rounds! I will start setting aside a "large plow plane with hollow and rounds" fund now.