hey all,
this is the first, official product i make on my new laser. what do you guys think? i would really appreciate your opinion about them, as i only made 15 now, and i am willing to change the design if you guys have better ideas.
the only thing i hate about it, is that the veneer is so thin, when i vector cut, it will sort of show through on the other side. the speed was 500 and the power was 10% (the lowest it will accept). i find if i go any faster than 500 it just doesnt seem to go any faster .
the way i actually placed these in the laser is that i got a piece of acrylic, placed double faced tape (as you can see in the picture) then gently pushed them down (because they do warp).
photo 3.jpgphoto 4.jpgphoto 5.jpgphoto 1.jpgphoto 2.jpg
(They do look better in person)
looking forward to your suggestions/opinions/thoughts!!