Results 1 to 3 of 3

Thread: Workbench build question 2

  1. 02-16-2013, 2:27 PM #1
    Dave Novak
    Dave Novak is offline [OP] Contributor
    Send a message via Yahoo to Dave Novak
    Join Date
    Jan 2007
    Location
    Springfield, IL
    Posts
    412

    Workbench build question 2

    I've started building a workbench; the top is laminated 8/4 hard maple, face glued, finished at 3 1/4" thick and 28" x7'. No skirt is planned, however the end vice (LN chain drive) will require a 5 1/4 back jaw permanently attached to the end grain of the laminated top pieces. How would you tackle this taking into account wood movement?
    Reply With Quote Reply With Quote
  3. 02-16-2013, 3:14 PM #2
    Myk Rian's Avatar
    Myk Rian
    Myk Rian is offline Contributor
    Join Date
    Jun 2006
    Location
    The Hartland of Michigan
    Posts
    7,628
    Why 2 threads?
    Never, under any circumstances, consume a laxative and sleeping pill, on the same night
    Reply With Quote Reply With Quote
  4. 02-16-2013, 3:16 PM #3
    Dave Novak
    Dave Novak is offline [OP] Contributor
    Send a message via Yahoo to Dave Novak
    Join Date
    Jan 2007
    Location
    Springfield, IL
    Posts
    412
    I don't know, different questions
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules