Results 1 to 3 of 3

Thread: Delta Midi lathe bed exstention

  1. 03-01-2013, 4:53 PM #1
    Terry Murphy's Avatar
    Terry Murphy
    Terry Murphy is offline [OP] Member
    Join Date
    Dec 2008
    Location
    Coeur d'alene, Idaho
    Posts
    148

    Delta Midi lathe bed exstention

    Does anyone know the size bolt the bed exstention uses?

    Terry
    It's all fun!

    Terry
    Reply With Quote Reply With Quote
  3. 03-01-2013, 5:29 PM #2
    Aric Krueger
    Aric Krueger is offline Member
    Join Date
    Dec 2012
    Location
    Quincy, CA
    Posts
    59
    If it is a Delta 46-460, and you are referring to the bed extension (part # 46-463), you will need four M8 hex head bolts and four M8 lock washers. (That's according to the instruction sheet that comes with the extension bed). They are probably available at your local hardware store. Hope that helps. Good Luck and Happy Turning!
    Reply With Quote Reply With Quote
  4. 03-01-2013, 6:36 PM #3
    Terry Murphy's Avatar
    Terry Murphy
    Terry Murphy is offline [OP] Member
    Join Date
    Dec 2008
    Location
    Coeur d'alene, Idaho
    Posts
    148
    Very good Eruc. Thank you.
    It's all fun!

    Terry
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules