I recently got the Incra TS-LS fence, and I'm totally sold on it. However, I managed to have a slight fender bender in my shop and the main fence rails were knocked slightly askew in their brackets. No problem, I'll just take it all apart and follow the (very good) manual through again. On step 1, I hit a snag. You're supposed to used one portion of a bracket as a jig to align the rails to the saw surface at just the right offset. After that, you install some black plastic they call Glide Pads onto the brackets for use in a later assembly. So, now I'm in the position where I have the glide pads installed but need to re-use the brackets as alignment jigs again. Anyone else been through this and have an idea what to do?
It's after business hours so I figured I'd ask SMC to see if anyone gets back to me tonight.