I'm making up a table top for a shaker table out of three boards. I got them flat but one of the boards had more bow in it than the others. It is now just about a 1/16th (I'm horrible at guesstimates) or more below the other two boards -- there a noticeable ridge between the boards. It was suggested elsewhere that I go ahead and glue them up and go at it (even though none of them are perfect*).
So should I just glue them up and work the other two boards down to it? BTW it's the middle of the three. Should I get the other two closer to it? Should I just cut out another board that would get closer the the finished width?
* others still have a little bit of the concavity left on that side of the board whereas the convex side is as close to flat as I can manage.