Hello everyone,
I just sent off payment for a Rabbit RL-60-1290, thanks to my research that started here I didn't purchase my machine from Nevada. The staff at Rabbit have been a huge help, cutting the samples that I sent them.
I design, prototype and sew nylon gear for hunting and military use, as a one man shop I am looking for time savers. My bags and pouches are fairly simple but it does take a fair amount of time to mark and cut each piece of fabric using cardboard patterns.
Since my primary use of the machine is for vector cutting with future ideas of rastering, I'm curious as to what "simple" program you would recommend. I'm planning on purchasing a laptop to run this machine and at this point I'm looking towards Coral Draw, but before I spend the money on that I wanted some more input.
Thanks, Scott