Square cut off by .15mm

[Stan Krupowies]

I think I know the answer to this but I was just wondering what you guys would do. I set up my MFT/3 and when I do the 5 cut check, the last cut is 17.6mm on the far end and 17mm on the near end. Dividing that by 4 gives me out of square by .15mm or 0.01" on a 14" cut. Would any of you try to tweak that closer or would you leave it as is?

Stan

[pat warner]

Easily that much error in your measurements. Unless you're dial indicating on granite.
Don't mess with it, be happy, don't worry.

[David Eisenhauer]

I can't even see those increments on my Lufkin 6' folding ruler. Not even on the brass depth slide out.

[Harvey Miller]

You're at 1.5 times the thickness of a human hair (0.1mm).

[Tom Ewell]

saw dust on the fence will cause more than that.

[Martin Wasner]

I don't know at a mft/3 is, maybe whatever it is isn't capable of big cuts so it doesn't matter but I would. That's a lot for just 14". Extrapolate that out over 60" and you're talking almost a 1/16".

[Martin Wasner]

If it were off that amount in 5' I'd say don't sweat it, it's inconsequentially off