How to make a hole in a corner?

[Pat Barry]

I went to Menards after work and found this Hitachi flex attachment for my Makita. It works very good for what I needed. The collet is only about 1/2" diameter so it got nicely into the corner, maybe a little over 1/4 from the corner. It was only $11.99. This one wouldn't quite make a 90 degree turn but that was ok for my task today.
Thanks Sean!
flex drill.jpg

[Pat Barry]

Lights off:
LightsOff1.jpg

Lights on:
LightsOn1.jpg

Getting close now, just need to install the glass, clean up the wiring, buff it out with some wax and install the knobs for the upper and lower doors.

[Sean Hughto]

Great looking cabinet!

[Pat Barry]

Thanks Sean! Its been in work for quite a while. Way too long actually/

[Jessica Pierce-LaRose]

Nice work! Looking great!
I was thinking push drill, too, but I've never seen one go out to 3/16" bits