Hi All, I went on a plane making/modding binge over the weekend and made a dedicated scrubber to replace (well, add to) a cambered #5. I modded a 35 razee plane that was in good shape but seldom used. The iron is a piece of 1/8" X 1-1/4" O1 steel that I milled when soft then hardened and tempered.
The only thing that makes this plane something I haven't seen before was that I filed the yoke post to fit the little holes in the iron. By driving the center screw deeper into the frog, I can use the depth adjustment wheel without needing a chip breaker. The lever cap holds everything in place although I did glue a couple strips of rosewood on either side of the bedding surface to keep the iron centered.
FWIW, Skip
35 scrubber guts.jpg
35 scrubber post.jpg
35 mouth.JPG