i'm just getting started with this, but have run into a little snag.
i'm engraving on a variety of wood samples. i've designed a template in corel that lets me stack by bed side-by-side with 28 samples (5" square samples). the engraving is the same on each sample.
in corel, i make a 5" square box, added my text in the proper spots, and grouped all of this together. i copied and arranged them to fill up the overall space (set to match my laser bed). i then ungrouped everything and deleted the 5" square boxes. this leaves the text only, which is all i want the laser to engrave, arranged to engrave in the center of 28 different pieces.
i'm running to issues when i just want to engrave one, 5" square area like above. i'm only exporting a single box, but without the actual 5" box, so just the text. when i open it up in laser cut, it has been resized. this makes it significantly more difficult to line up, since i was just dragging it to the upper right hand corner and cutting.
anyway to get corel/lasercut to not resize my image? i could keep the box line, but then i would need to figure out how to not have the laser engrave that line.