Hi,
It never occurred to me to set boards on edge and run them through my planner to end up with boards of identical width.
A couple years ago someone mentioned doing this to me, and I tried it once and it seemed to work. The only advantage I see is perhaps having a smoother surface than a rip blade on the table saw would produce.
The wood I tried was not that tall, probably 3/4 inch wide and less than 2 inches high.
How crazy is this idea?
The more I think about it, the crazier it becomes!
Is there any real use for such a procedure? The more I think about it, the more I will just try to forget the idea!
Unless i I am missing something!
Bill