Hey Folks - New here, second post.
I'll go and fill out profile a bit tonight.
Considering a DW 735, almost exclusive use will be 1" SYP already S4S from local lumberyard when I buy them, just to clean them up even better, get rid of factory ripple, etc.
And occasionally small quantity to thin down to 5/8" or even 1/2".
My lumber will have tight knots.
My pieces will be up to 8' long. Usually 6" or 8" wide.
The wood may not be super dry, maybe high as 14% I think.
Need to buy a meter, then go to the yard.
I did Advanced search and have read most of the DW 735 posts, will finish tonight.
I've read about the extension tables need, no problem. Would do that anyway. Don't want to be chasing boards before they hit floor.
Anything to be aware of peculiar to pine ?
Resin loading problems?
Knife damage from knots ?
Any ballpark wild estimate how much it will do till blades need service?
Lastly - A totally different use, would be less than 100 lin ft of already S4S Oak , probably 12% or dryer 2" x 12" x12', with a good sturdy and long in and out roller tables.
Any trouble there?
Thank you all... EXCELLENT Forum.
Marc