Beautiful work - and this might be a dumb question, but what combination of chucks and/or spindles did you use to turn the lid?
Contributor
Beautiful work - and this might be a dumb question, but what combination of chucks and/or spindles did you use to turn the lid?
[OP]
Member
2 inch jaws in a 2 1/8 inch shallow recess made with a forstner bit in the bottom side. Shaped the top and bored a 3/4 inch hole 1/2 inch deep in the top. Then flipped it into a set of pin jaws to shape the bottom and remove the recess.
Originally Posted by Mike Walsh
Posting Permissions
Reply With Quote