I've been thinking about getting a Japanese hammer for joinery work.
Any recommendations?
Thanks in advance.
I've been thinking about getting a Japanese hammer for joinery work.
Any recommendations?
Thanks in advance.
Mine came from the Lee Valley Clearance bin some years back for $10. I made a lovely larger curved handle from hickory that added weight, accuracy and comfort. Really like using it.
You can do a lot with very little! You can do a little more with a lot!
Can you be more specific as to which hammer? I looked at hammers and did not see a "Japanese hammer" at Lee Valley, but I only spent a few minutes looking at it. Is this a hammer to adjust a plane?
I don't see any there either. (Hence, perhaps, the clearance bin....)
Search this site for "Gennou". There have been several threads, e.g:
The Japanese Gennou (Hammer)
Gosh, I sure miss Stan Covington. Excellent resource of information re all tools of Japan.
Found a picture with it in, my new handle. Clearance bin from some years back, at least 7. Original handle was smaller straight and lighter, did nothing for me. Inspired by a thread on here to make the new handle, it transforms the hammer.
8493499B-843D-4B4A-83A4-409730FC8612.jpg
Last edited by William Fretwell; 06-18-2019 at 7:08 AM. Reason: Better picture
You can do a lot with very little! You can do a little more with a lot!
Joel Google Covington and sons tools and it will take you to Stan's blog. You can contact him through the info on his blog and I'm sure he will provide you with all the information you require.
Hi David
I have a couple of gennous. For Japanese bench chisels, when dovetailing - that is, gentle work - my preferred size is a 225gm head.
Tenryu Tsuchime Shikaku. The one at the rear is 325gm, which is better for moderate blows.
The one downside to these hammers is that they can be noisy. For times of quiet, I use this UHMW-headed mallet, which began life as one from Lee Valley. The UHMW has excellent characteristics, combining feedback and non-destructive contact.
Regards from Perth
Derek
Last edited by Derek Cohen; 06-18-2019 at 7:37 PM.
Derek...
Do you recommend a vendor for the 225g Tenryu Tsuchime Shikaku? Thanks...
- David
David ...
http://www.japan-tool.com/
Regards from Perth
Derek