Well ..almost done. Good enough to start working on. Fir 2x4 and 2x6. Top seems like it weighed 100 pounds when done. I wanted a middle tool well so that I could work on both sides of it. Besides holding all the little stuff, it also serves as a stop for edge joining boards. All my bench dogs are 3/4 oak dowels, some are capped with an oak square. Top is joined to the frame with oak dowels on each corner. Open lower shelf stores the clamps and planes. Finish is a wipe on Watco poly. Still needed are end vice install, and retractable castors. I'm very pleased with it- it certainly beats clamping work to my table saw.