Old buddy of mine was talking about a capacitor-enabled "green outlet" that an HVAC contractor installed for the motor starter on his mother's furnace. After spending a few minutes barking down internet rabbit holes, I found these thing-um-bobs, among others:
https://www.raymondinnovations.com/?...UaApiPEALw_wcB
I'm curious to know whether anyone here has used such devices on a planer, table saw, or equivalent "biggish" tool, and if so whether your experience was positive, neutral, or negative (no electrical puns intended, I swear).
So... any thoughts?
Thanks.
Cheers,
Jack